how to tighten compression fittings

0 Comments 18:51

how to tighten compression fittings插图

Best answer


Hold the compression fitting body tightly with a pair of grips and tighten the nut with a spanner. Its often said in the trade to not over tighten a compression fitting,leaving you more thread in the case of a leak and not distorting the olive or fitting. Generally a nut will need one whole turn after hand tightening.

People also ask


  • Is it possible to over tighten compression fittings?

  • Its often said in the trade to not over tighten a compression fitting, leaving you more thread in the case of a leak and not distorting the olive or fitting. Generally a nut will need one whole turn after hand tightening.

  • How do you tighten brass compression fittings?

  • How do you tighten brass compression fittings? Hold the compression fitting body tightly with a pair of grips and tighten the nut with a spanner. Its often said in the trade to not over tighten a compression fitting, leaving you more thread in the case of a leak and not distorting the olive or fitting.

  • How do you install a compression fitting on a pipe?

  • Clean the outside of the pipe, making sure that there is no pipe residue, dirt or grit is present near the joint. Remove the compression nut and compression olive, then put the nut on the tube, followed by the olive. Insert the tube end up to the fitting’s tube stop. Slide the olive and the nut down to the fitting body.

  • How do compression fittings work?

  • Compression fittings are designed to mechanically form a joint between the fitting and the pipe. When tightening the nut, you are compressing the olive onto the tube, creating a permanent seal.

    Leave a Reply

    Your email address will not be published.

    Related Post